Instruction manual

SmartWatch® IP PTZ Dome Cameras - Manual

directory. The files will be saved in a sub-folder in FTP server. The name

of folder can be defined as shown in following Figure 6-19.

Child Directory

 Upload type: To enable uploading the captured picture to the FTP server.

3. Click to save the settings.

If you want to upload the captured pictures to FTP server, you also have to enable

the continuous snapshot or event-triggered snapshot in Snapshot interface. For detailed

information, please refer to the Section 7.3 Configuring Snapshot Settings.

6.3.9 Configuring UPnP™ Settings

Universal Plug and Play (UPnP™) is a networking architecture that provides

compatibility among networking equipment, software and other hardware devices.

The UPnP protocol allows devices to connect seamlessly and to simplify the

implementation of networks in domestic and corporate environments.

With this function enabled, you don’t need to configure port mapping for each port,

and the camera is connected to the Wide Area Network via the router.

Steps:

1. Enter the UPnP™ settings interface.

Configuration >Advanced Configuration > Network > UPnP

2. Check the checkbox to enable the UPnP™ function.

You can edit the Friendly Name of the speed dome. This name can be detected by

corresponding device, such as a router.

Configure UPnP Settings

6.3.10 Configuring NAT (Network Address Translation) Settings

Steps: