Instruction manual

SmartWatch® IP PTZ Dome Cameras - Manual
27
Chapter 5 PTZ Configuration
5.1 Configuring Initial Position
Purpose:
The initial position is the home position of the PTZ.
 To Customize an Initial Position:
Steps:
1. Enter the Initial Position Configuration page:
Configuration > Advanced Configuration > PTZ > Initial Position
PTZ Configuration
2. Click the PTZ control buttons and go to the initial position.
3. Click to save the position.
 Call/delete an Initial Position:
Click to call the initial position. Click to delete the initial
position.
5.2 Configuring Basic PTZ Parameters
To configure the basic PTZ parameters, proportional pan, preset freezing, preset speed,
etc.