Instruction manual

SmartWatch® IP PTZ Dome Cameras - Manual
25
 Buttons on the Patrols interface:
Buttons
Description
Save patrol
Call patrol
Stop patrol
Enter a preset
Modify a preset
Delete a preset
Delete all presets in one patrol
4.4.4 Setting / Calling a Pattern
Purpose:
A pattern is a memorized series of pan, tilt, zoom, and preset functions. It can be called
on the pattern settings page. You can configure 4 patterns.
 Setting a Pattern:
Steps:
1. In the PTZ control panel, click to enter the pattern config page.
2. Select a pattern number from the list as shown in Figure 4-9.
Patterns Settings Interface
3. Click to enable recording the pan, tilt and zoom.
4. Use the PTZ control buttons to move the camera to the desired position. Pattern
Record Remaining Memory (%) will be displayed on the screen.
• Pan the speed dome to the right or left.
• Tilt the speed dome up or down.
• Zoom in or out.
• Refocus the lens.
5. Click to save all the pattern settings.