User manual

UserManualofIRNetworkSpeedDome

65
Chapter7 RecordSettings
Beforeyoustart:
Toconfigurerecordsettings,pleasemakesurethatyouhavethenetworkstorage
devicewithinthenetworkortheSDcardinsertedinyourspeeddome.
7.1 ConfiguringNASSettings
Beforeyoustart:
Thenetworkdiskshouldbeavailablewithinthenetworkandproperlyconfiguredto
storetherecordedfiles,logfiles,etc.
Steps:
1. Addthenetworkdisk
(1) EntertheNAS(NetworkAttachedStorage)Settingsinterface:
Configuration>AdvancedConfiguration>Storage>NAS

Figure71 AddNetworkDisk

(2) EntertheIPaddressofthenetworkdisk,andthedefaultformatoffilepathis
/dvr/shareasshowninFigure71.
Note:Thenetworkdiskfilepathnameshareisuserdefinedwhilecreatingthe
DVRnetworkstorage.PleaserefertotheUserManualofNASforcreatingthefile
path.
(3) Click  toaddthenetworkdisk.
Note:Afterhavingsavedsuccessfully,youneedtorebootthespeeddometo
activatethesettings.
2. Initializetheaddednetworkdisk.
(1) Enter the HDD Settings interface (Advanced Configuration > Storage >
StorageManagement),inwhichyoucanviewthecapacity,freespace,status,
typeandpropertyofthedisk.
(2) If the status of the disk is Uninitialized as shown in Figure 72, check the
corresponding checkbox to select the disk and click  to start
initializingthedisk.