User manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 Wi-Fi Settings
- Chapter 5 Live View
- Chapter 6 Network Camera Configuration
- 6.1 Configuring Local Parameters
- 6.2 Configuring Time Settings
- 6.3 Configuring Network Settings
- 6.4 Configuring Video and Audio Settings
- 6.5 Configuring Image Parameters
- 6.6 Configuring and Handling Alarms
- 6.6.1 Configuring Motion Detection
- 6.6.2 Configuring Tamper-proof Alarm
- 6.6.3 Configuring External Alarm Input
- 6.6.4 Configuring Alarm Output
- 6.6.5 Handling Exception
- 6.6.6 Email Sending Triggered by Alarm
- 6.6.7 Configuring Snapshot Settings
- 6.6.8 Face Detection
- 6.6.9 Configuring Other Alarms
- 6.6.10 Arming or Disarming the Camera
- Chapter 7 Storage Settings
- Chapter 8 Playback
- Chapter 9 Log Searching
- Chapter 10 Others
- Appendix
User Manual of Network Camera
65
Steps:
1. Enter the face detection settings interface:
Configuration > Advanced Configuration > Events > Face Detection
2. Check the Enable Face Detection to checkbox to enable the function.
3. (Optional)You can check the Enable Dynamic Analysis for Face Detection
checkbox if you want the face detected get marked with rectangle in the live
view.
4. Configure the sensitivity of face detection. The default value is 5.
5. (Optional)You can also configure the linkage action for face detection.
6.6.9 Configuring Other Alarms
Purpose:
This section is for the camera supporting external wireless alarm (e.g. access control
alarm), embedded PIR (passive infrared sensor) alarm and manual alarm by remote
control.
Study the wireless alarm and the remote control
Purpose:
The wireless alarm is the function of the camera to communicate to wireless alarm
devices such as the access control. The remote control or other remote alarm devices
must be compatible and learn each other’s remote signal to communicate.
Before configure the wireless alarm, the camera must study the code of the wireless
alarm device.
Steps:
1. Enter the Remote Control interface:
Configuration> Advanced Configuration> System > Remote Control