User manual

User Manual of Network Camera

start importing configuration file.

Note: You need to reboot the camera after importing configuration file.

2. Click and set the saving path to save the configuration file in local

storage.

Figure 10-14 Import/Export Configuration File

10.6.4 Upgrading the System

Steps:

1. Enter the Maintenance interface:

Configuration > Basic Configuration> System > Maintenance

Or Configuration > Advanced Configuration> System > Maintenance

2. Click to select the local upgrade file and then click to start

remote upgrade.

Note: The upgrading process will take 1 to 10 minutes. Please don't disconnect

power of the camera during the process. The camera reboots automatically after

upgrading.

Figure 10-15 Remote Upgrade

10.7 RS-232 Settings

Purpose:

The RS-232 port can be used in two ways:

 Parameters Configuration: Connect a computer to the camera through the serial

port. Device parameters can be configured by using software such as

HyperTerminal. The serial port parameters must be the same as the serial port

parameters of the camera.

 Transparent Channel: Connect a serial device directly to the camera. The serial

device will be controlled remotely by the computer through the network.

Steps: