Installation Manual









72%27720('*(2)

%('6,'(

Installation Guide

SC103D - Driver Side

Chevy Colorado / GMC Canyon 2015

For Warranty Issues, Contact UnderCover Directly

(866) 900-8800 www.undercoverinfo.com

Form # SC103DII

Created March 2015

SC103D

Hardware Included

1. Truck Bracket

2. Striker Bracket

3. Mounting Screws (qty 6)

4. Assembly Nuts (qty 2)

Hardware Included

1. Truck Bracket

2. Striker Bracket

3. Mounting Screws (qty 6)

4. Assembly Nuts (qty 2)

Note: It is not necessary to remove this tie down.

11 7/8”

(302 mm)

1. BRACKET ASSEMBLY - Attach the striker bracket to the truck bracket using the two (2) assembly nuts.

2. INSTALLING MOUNTING BRACKET ASSEMBLY - Position the bracket assembly according to the drawing,

measure from the top of the striker bracket to the bottom edge of the bed rail, 11 7/8” (302mm). Attach

the bracket with the mount-

ing screws, starting with the

top left screw. Make sure the

bracket is level with the bed

rail and nish install with

remaining screws.

Keep ush to bed, stay o of radius.

PAGE 1
Installation Guide D SC103D SC103D - Driver Side Chevy Colorado / GMC Canyon 2015 1 2 3 4 1 Hardware Included 1. Truck Bracket 2. Striker Bracket 3. Mounting Screws (qty 6) 4. Assembly Nuts (qty 2) Note: It is not necessary to remove this tie down. 2 1. BRACKET ASSEMBLY - Attach the striker bracket to the truck bracket using the two (2) assembly nuts. 2.
PAGE 2
Installation Guide - Continued 4 5 4. INSTALLING SWING CASE Lower the box onto the hinge pins and gently push the box to the stowed position. 5. OPERATION AND ADJUSTMENT Pull the latch rod and swing through the full motion making sure it operates freely and latches easily. Do not slam the box to stow it, if it will not latch easily it may be necessary to make some minor adjustments. The latch has slotted holes, just loosen the two bolts and adjust as needed.