Installation Manual

SC100D - Drivers Side

Chevy/GMC 2007 - Current









Hardware Included

1. Truck Bracket

2. Striker Bracket

3. Mounting Screws (qty 6)

4. Assembly Nuts (qty 2)

1. BRACKET ASSEMBLY - Attach the striker bracket to the truck bracket using the two (2) assembly nuts.

2. INSTALLING MOUNTING BRACKET ASSEMBLY - Position the bracket to the light well/wheel well area. It

is not necessary to remove the tie down.

3. INSTALLING MOUNTING BRACKET ASSEMBLY (continued)

Mount the bracket approximately 1

3/4” above the oor, according to the

drawing. Using the six (6) self drilling screws provided, attach the brack-

et to the truck . Be careful not to overtighten and strip out the holes.

3 4

1.75”

(44 mm)

www.undercoverinfo.com

UnderCover, Inc.

February, 2017

Part Number - SC100D

SC100D

PAGE 1
SC100D SC100D - Drivers Side Chevy/GMC 2007 - Current 1 2 3 Hardware Included 1. Truck Bracket 2. Striker Bracket 3. Mounting Screws (qty 6) 4. Assembly Nuts (qty 2) 4 2 1 1. BRACKET ASSEMBLY - Attach the striker bracket to the truck bracket using the two (2) assembly nuts. 2. INSTALLING MOUNTING BRACKET ASSEMBLY - Position the bracket to the light well/wheel well area. It is not necessary to remove the tie down. 3 1.75” mm) (44 3.
PAGE 2
5 4 4. INSTALLING SWING CASE Lower the box onto the hinge pins and gently push the box to the stowed position. 5. OPERATION AND ADJUSTMENT Pull the latch rod and swing through the full motion making sure it operates freely and latches easily. Do not slam the box to stow it, if it will not latch easily it may be necessary to make some minor adjustments. The latch has slotted holes, just loosen the two bolts and adjust as needed. Be sure to blow or sweep the metal shavings out of the truck bed.