User Manual

10. Install the hydraulic struts,
attach the large end to the cover
and the rod end to the Tango
Track system (these will snap into
place, no tools needed).
11. Snap front seal into channel on front Tango track.
Note: Spray liberal amount of glass cleaner or soap/water solution on Tango track for
easier install of front seal.
9. With some assistance place the cover onto the front mounting brackets. . Line the open slot up in
the hinge with the pin on the mounting bracket. Push the cover forward to lock it into place. Tighten
knob until it stops, it may be necessary to push the hinge up tight to the mounting bracket to help
the threads engage, be careful not to cross thread and strip the bracket.
© 2016 UnderCover, Inc.
All rights reserved.
UnderCover, Inc.
[phone]
www.undercoverinfo.com
Page 5
Ridgelander Cover Installation
Line Up Slot
Push Forward
Tighten Knob
Rod End