User Manual

5. Slide the left rail assembly in place by inserting the L bracket in to the T-slot, do not tighten
Note: Lift up on the front rail assembly to create enough room to insert the L bracket into the T-slot.
Note: Be sure side rubber is not pinched under rail assembly.
6. Push Tango system towards bulkhead, install all remaining clamps and tighten.
Note: Put downward pressure on Tango rails as you tighten clamps.
After all 8 clamps are tight, tighten set screws on front L brackets using 3mm allen wrench.
© 2016 UnderCover, Inc.
All rights reserved.
UnderCover, Inc.
[phone]
www.undercoverinfo.com
Page 3
Tango Track Installation (continued)
Tighten clamps 1st
Tighten L brackets 2nd
Side Seal - Correct
Side Seal - Incorrect