OWNER’S MANUAL WWW.YBIKE.CO.
IMPORTANT SAFETY NOTICE WARNING SAFETY PRECAUTIONS: Riding this product can be a hazardous activity and precautions should be taken to avoid dangerous situations. Be sure to read the entire manual before riding. Please pay close attention to the following precautionary measures: WARNING! This bike is intended to be assembled by an adult. Children riding this product should have constant adult supervision.
The product should only be used on flat and level ground. DO NOT ride the balance bike on slopes. DO NOT go down a long descending slope or hill. Please be careful when passing these areas. Ensure that the product’s handlebar is securely fixed and that it moves smoothly by turning it left and right before allowing your child to use the product. DO NOT use attachments not included in packaging or attempt to do any modifications yourself as this may compromise the safety of the product.
TOYNI PARTS LIST & COMPONENTS Open the box and take out all of its contents. Make sure all of the parts and components listed below are included: 1 2 4 3 6 5 7 No.
ASSEMBLY INSTRUCTIONS 10 1. Front Wheel Fork Assembly 9 Position the Wheel Fork (No. 2) and Handlebar (No. 9) into the hole in The Main Body (No. 1) as shown. Ensure that the Wheel Fork is correctly positioned inside the Handlebar. Push the Fork Bolt (No. 6) down the hole from the top of the Handlebar (No. 9) and through the Wheel Fork (No.2). 6 2 9 1 NOTE: The Front Wheel Fork (No. 2) must be positioned with the steering guide facing forward as shown above. 2 Screw the Bolt Cap (No.
ASSEMBLY INSTRUCTIONS 2. Front Wheel Assembly Position the Front Wheel (No.4) between the arms of the Wheel Fork (No.2) with their holes aligned. Push the Front Wheel Bolt (No.7) through the holes in the Fork and Wheel. 8 10 Screw the Bolt Cap (No.8) into the threaded end of the Front Wheel Bolt (No.7) and tighten using the Allen Keys (No.10). 2 7 10 4 (Do not over tighten bolts as this may cause damage.
ASSEMBLY INSTRUCTIONS Back Wheel Assembly NOTE: The Shaft (No.11) has rectangular details. Ensure that it is correctly positioned when pushing it through the Main Body (No.1) & Back Wheels (No.3). Push the Shaft (No.11) through the hole at the back of the Main Body (No.1). Position Back Wheels (No.3) onto the Shaft on either side of the Main Body (No.1). Make sure that the Shaft protrudes slightly from the Wheels as shown. 1 5 Screw the Shaft Caps (No.5) onto either ends of the Shaft (No.11).
BALANCING SETTINGS HOW TO CHANGE THE BALANCING SETTING ON YOUR TOYNI: Unscrew and remove the Shaft Caps (No.5)*. Remove the Back Wheels, flip, reposition onto Shaft and reattach Shaft Caps (No.5) mm 155 BEGINNER BALANCING SETTING *Refer to page 6 for Assembly Diagram.
CHECK BEFORE RIDING 1. Check that all the bolts are securely tightened. 2. Check that the handlebar is securely fastened and that it moves smoothly. Check that the wheels can spin smoothly and that each part is securely fixed. 3. 4. Finally, after checking the above points, you can now start riding your new balance bike. WARNING! This product must be assembled by an adult. Read the manufacturer’s instructions before using. Keep the instructions safe for future reference. ENJOY YOUR YBIKE TOYNI WWW.
