Instructions / Assembly

7" XL TWO-PIECE WRAP AROUND
TOP & BOTTOM COVERS
7” XL WRAP
AROUND
TOP COVER
2 - Slide the outside cover into position and align
the hole in the cover with the cage nut attached
to the top plate.
Secure using
the 1/4”-20 x 3/4”
screw provided.
3 - Insert the front of the
top cover into the hole
in the front of the
outside cover.
Pull the back of the top
cover down until it
securely fits under the inside lip of the ledge.
Make sure the bottom lip on the back of the top
cover goes over the back edge of the ledge (Fig. 4).
OUTSIDE
COVER
1
LOGO
1/4”-20 X 3/4”
STAINLESS
STEEL
SCREW
2
1 - Insert the logo into
the cover.
23
TOP
COVER
3
4 - Align the holes on the side of the bottom wrap
with the holes on the top ofthe vertical.
If the holes are not there or the
cover does not reach
the holes simply drill a
new set of holes into
the vertical.
Secure the cover using
the #12 x 1/2” screws provided.
#12X1/2” SCREW
1 ON EACH SIDE
IMPORTANT:
Make sure that the
inside edge of the
top cover is securely
positioned over the
edge of the ledges
4