Product Manual

XBee/XBee‐PRO™OEMRFModules‐802.15.4‐v1.xAx[2007.05.031]
©2007MaxStream,Inc. 5
Chapter1‐XBee/XBee‐PROOEMRFModules
1.2. Specifications
*WhenoperatinginEurope:XBee‐PRORFModulesmustbeconfigured tooperateatamaximumtransmitpoweroutputlevel
of10dBm.ThepoweroutputlevelissetusingthePLcommand.ThePLparametermustequal“0”(10dBm).
Additionally,EuropeanregulationsstipulateanEIRP powermaximumof
12.86dBm(19mW)fortheXBee‐PROand12.11dBm
fortheXBeewhenintegratinghigh‐gainantennas.
**WhenoperatinginJapan:Transmitpoweroutputislimitedto10dBm.Aspecialpartnumberisrequiredwhenordering
modulesapprovedforuseinJapan.ContactMaxStreamformoreinformation
[call1‐801‐765‐9885orsende‐mailstosales@max‐
stream.net].
Antenna Options: The ranges specified are typical when using the integrated Whip (1.5 dBi) and Dipole (2.1 dBi) anten-
nas. The Chip antenna option provides advantages in its form factor; however, it typically yields shorter range than the
Whip and Dipole antenna options when transmitting outdoors. For more information, refer to the “XBee Antenna” appli-
cation note located on MaxStream’s web site (http://www.maxstream.net/support/knowledgebase/article.php?kb=153).
Tab le1‐01. SpecificationsoftheXBee/XBee‐PROOEMRFModules
Specification XBee XBee-PRO
Performance
Indoor/Urban Range up to 100 ft. (30 m) Up to 300’ (100 m)
Outdoor RF line-of-sight Range up to 300 ft. (100 m) Up to 1 mile (1500 m)
Transmit Power Output
(software selectable)
1mW (0 dBm) 60 mW (18 dBm) conducted, 100 mW (20 dBm) EIRP*
RF Data Rate 250,000 bps 250,000 bps
Serial Interface Data Rate
(software selectable)
1200 - 115200 bps
(non-standard baud rates also supported)
1200 - 115200 bps
(non-standard baud rates also supported)
Receiver Sensitivity -92 dBm (1% packet error rate) -100 dBm (1% packet error rate)
Power Requirements
Supply Voltage 2.8 – 3.4 V 2.8 – 3.4 V
Transmit Current (typical) 45mA (@ 3.3 V)
If PL=0 (10dBm): 137mA(@3.3V), 139mA(@3.0V)
PL=1 (12dBm): 155mA (@3.3V), 153mA(@3.0V)
PL=2 (14dBm): 170mA (@3.3V), 171mA(@3.0V)
PL=3 (16dBm): 188mA (@3.3V), 195mA(@3.0V)
PL=4 (18dBm): 215mA (@3.3V), 227mA(@3.0V)
Idle / Receive Current (typical) 50mA (@ 3.3 V) 55mA (@ 3.3 V)
Power-down Current < 10 µA < 10 µA
General
Operating Frequency ISM 2.4 GHz ISM 2.4 GHz
Dimensions 0.960” x 1.087” (2.438cm x 2.761cm) 0.960” x 1.297” (2.438cm x 3.294cm)
Operating Temperature -40 to 85º C (industrial) -40 to 85º C (industrial)
Antenna Options Integrated Whip, Chip or U.FL Connector Integrated Whip, Chip or U.FL Connector
Networking & Security
Supported Network Topologies Point-to-point, Point-to-multipoint & Peer-to-peer
Number of Channels
(software selectable)
16 Direct Sequence Channels 12 Direct Sequence Channels
Addressing Options PAN ID, Channel and Addresses PAN ID, Channel and Addresses
Agency Approvals
United States (FCC Part 15.247) OUR-XBEE OUR-XBEEPRO
Industry Canada (IC) 4214A XBEE 4214A XBEEPRO
Europe (CE) ETSI ETSI (Max. 10 dBm transmit power output)*
Japan n/a 005NYCA0378 (Max. 10 dBm transmit power output)**