Product Manual

XBee/XBee‐PRO™OEMRFModules‐802.15.4‐v1.xAx[2007.05.031]
©2007MaxStream,Inc. 28
Chapter3‐RFModuleConfiguration
A2 ( v1.x80*)
Networking
{Association}
Coordinator Association. Set/Read Coordinator association options.
bit 0 - ReassignPanID
0 - Coordinator will not perform Active Scan to locate available PAN ID. It will operate
on ID (PAN ID).
1 - Coordinator will perform Active Scan to determine an available ID (PAN ID). If a
PAN ID conflict is found, the ID parameter will change.
bit 1 - ReassignChannel -
0 - Coordinator will not perform Energy Scan to determine free channel. It will operate
on the channel determined by the CH parameter.
1 - Coordinator will perform Energy Scan to find a free channel, then operate on that
channel.
bit 2 - AllowAssociation -
0 - Coordinator will not allow any devices to associate to it.
1 - Coordinator will allow devices to associate to it.
bits 3 - 7 are reserved
0 - 7 [bitfield] 0
AI ( v1.x80*)
Networking
{Association}
Association Indication. Read errors with the last association request:
0x00 - Successful Completion - Coordinator successfully started or End Device
association complete
0x01 - Active Scan Timeout
0x02 - Active Scan found no PANs
0x03 - Active Scan found PAN, but the CoordinatorAllowAssociation bit is not set
0x04 - Active Scan found PAN, but Coordinator and End Device are not
configured to support beacons
0x05 - Active Scan found PAN, but the Coordinator ID parameter does not match
the ID parameter of the End Device
0x06 - Active Scan found PAN, but the Coordinator CH parameter does not match the
CH parameter of the End Device
0x07 - Energy Scan Timeout
0x08 - Coordinator start request failed
0x09 - Coordinator could not start due to invalid parameter
0x0A - Coordinator Realignment is in progress
0x0B - Association Request not sent
0x0C - Association Request timed out - no reply was received
0x0D - Association Request had an Invalid Parameter
0x0E - Association Request Channel Access Failure. Request was not transmitted -
CCA failure
0x0F - Remote Coordinator did not send an ACK after Association Request was sent
0x10 - Remote Coordinator did not reply to the Association Request, but an ACK was
received after sending the request
0x11 - [reserved]
0x12 - Sync-Loss - Lost synchronization with a Beaconing Coordinator
0x13 - Disassociated - No longer associated to Coordinator
0 - 0x13 [read-only] -
DA ( v1.x80*)
Networking
{Association}
Force Disassociation. End Device will immediately disassociate from a Coordinator (if
associated) and reattempt to associate.
--
FP ( v1.x80*)
Networking
{Association}
Force Poll. Request indirect messages being held by a coordinator. - -
Table3‐02. XBee/XBee‐PROCommands‐Networking&Security(Sub‐categoriesdesignatedwithin{brackets})
AT
Command
Command
Category
Name and Description Parameter Range Default