Installation Guide

14
Option 2 - Power Cord Kit Installations
For optional power cord kit installations, follow the instructions
supplied with the power cord kit. See the “Accessories” section
for information on ordering.
NOTE: Use only with range hood cord connection kits that have
been investigated and found acceptable for use with this model
range hood.
Complete Installation
1. Replace grease filter if removed. See the “Range Hood Care”
section.
2. Check the operation of the range hood fan and light. See the
“Range Hood Use” section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect "wer and check wiring connections.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors,
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after
the cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the front panel of the range
hood.
Range Hood Controls
NOTE: The control buttons will light up when the range hood
is ON.
Light button
Press LIGHT once to turn the LED lights on.
Press LIGHT again to turn the LED lights off.
Boost button
Press BOOST to turn the fan on at the highest speed. Boost will
automatically turn off after 10 minutes and the fan will switch to
high speed.
High button
Press HIGH to turn the fan on at high speed.
Med button
Press MED to turn the fan on at medium speed.
Low button
Press LOW to turn the fan on at low speed.
Off button
Press OFF to turn the fan off at any speed.
Timer
The range hood can be set to automatically turn off after
15 minutes.
Press and hold the desired fan speed button (C, D, or E in the
previous image) for 3 seconds. The fan will run on the chosen
speed for 15 minutes and the fan speed button light will flash
continuously. After 15 minutes, the fan will turn off automatically.
To cancel the timer, press a different fan speed button while the
timer is running.
Grease Filter Timer
The grease filter timer can remind you when to clean or replace
the grease filter. It is OFF by default.
■ To enable the grease filter timer, push and hold the Low
button and the Off button at the same time for 3 seconds
while the range hood is OFF. Repeat to disable the function.
■ After 40 hours of fan use, the Off button will begin to blink.
The blinking light indicates that the grease filter should be
cleaned.
■ To reset the grease filter timer, press and hold OFF for
3 seconds.
A
B
C
D
A
B
C
D
E
F
A. Blower and light touch control
B. LED lamps
C. Filter retainer
D. Grease filter
A. Light button
B. Boost button
C. High Speed button
D. Medium Speed button
E. Low Speed button
F. Off button