Datasheet

ManualsBrandsUnbranded ManualsLEDs & AccessoriesLED wired Red Circular 5 mm 5000 mcd 15 ° 30 mA 1.9 V

SPECIFICATION

PART NO. : WU-8-56SEC

5.0mm ROUND LED LAMP

Approved by Checked by Prepared by

Tung Yang Min Bao

Vossloh Schwabe Optoelectronic GmbH & Co. KG

47475 Kamp-Lintfort

TEL: 02842-980-0

FAX: 02842-980-297

Http://www.vs-optoelectronic.com

VER.: 01 Date: 2007/08/10 Page: 1/5

Summary of content (5 pages)

PAGE 1
Vossloh Schwabe Optoelectronic GmbH & Co. KG 47475 Kamp-Lintfort TEL: 02842-980-0 FAX: 02842-980-297 Http://www.vs-optoelectronic.com SPECIFICATION PART NO. : WU-8-56SEC 5.0mm ROUND LED LAMP Approved by Checked by Prepared by Tung Yang Min Bao VER.
PAGE 2
5.0mm ROUND LED LAMP WU-8-56SEC Description This hyper red lamp is made with AlGaInP/GaAs chip and water clear 24.0 MIN. 1.5 TYP. 0.5 MAX. 8.7 5.9 epoxy resin. K A Notes: 1. All dimensions are in mm. 2. Tolerance is±0.25mm unless otherwise noted Description LED Chip Part No. WU-8-56SEC Material Emitting Color AlGaInP/GaAs Hyper red VER.
PAGE 3
5.0mm ROUND LED LAMP WU-8-56SEC Absolute Maximum Ratings at Ta=25℃ Parameter Symbol Rating Unit Power Dissipation PD 72 mW Reverse Voltage VR 5 V D.C. Forward Current If 30 mA Reverse (Leakage) Current Ir 100 μA If(Peak) 100 mA Operating Temperature Range Topr. -25 to +85 ℃ Storage Temperature Range Tstg. -40 to +100 ℃ Soldering Temperature(1.6mm from body) Tsol. Peak Current(1/10Duty Cycle,0.1ms Pulse Width.) Dip Soldering : 260℃ for 5 sec.
PAGE 4
5.0mm ROUND LED LAMP WU-8-56SEC Typical Electrical / Optical Characteristics Curves : 10000 Relative Luminous Intensity Forward Current IF(mA) 50 40 30 20 10 1.2 1.6 2.0 2.4 2.8 8000 6000 4000 2000 0 3.2 Applied Voltage (V) 30.0 Forward Current (mA) FORWARD CURRENT VS.APPLIED VOLTAGE FORWARD CURRENT VS. LUMINOUS INTENSITY 0° 50 Forward Current IF(mA) 20.0 10.0 0.0 20° 10° 30° 40 40° 30 1.0 20 50° 0.9 60° 0.8 70° 80° 90° 10 0.7 0 20 40 60 Temperature(。C) 80 100 0.
PAGE 5
WU-8-56SEC 5.0mm ROUND LED LAMP Precautions: TAKE NOTE OF THE FOLLOWING IN USE OF LED 1. Temperature in use Since the light generated inside the LED needs to be emitted to outside efficiently, a resin with high light transparency is used; therefore, additives to improve the heat resistance or moisture resistance (silica gel , etc) which are used for semiconductor products such as transistors cannot be added to the resin.