Instructions / Assembly

Operating Conditions:
Working Conditions
Working pressure 21psi to 120psi
Water temperature
40 °F - 120 °F (5°C - 50°C)
Working Environment
Environment
temperature
40 °F - 120 °F (5°C - 50°C)
Relative humidity （
≤ 95% When temperature is 25°C/77°F
Power source AC100 ～ 240V/50 ～ 60Hz
Inlet Water Quality
Water turbidity Down-flow Regeneration < 5FTU
Water hardness 1 grain per gallon (gpg) = 17.1 parts per million (ppm)
Chlorine
< 0.1ppm
Iron
2+
< 0.3ppm
Operating Conditions
This softening system will operate at maximum efficiency when the following conditions are considered:
4
• All plumbing and electrical work should be performed by an accredited professional to ensure all local, state, and
municipal guidelines are met.
• Do not use the control valve with water that is unsafe or of unknown quality.
• Do not use the brine tube, injector body, or other connectors on the valve as a handle to carry the system.
• Ensure there is salt in the brine tank at all times when in use for softening. The brine tank should contain clean
water softening salt only, at least 99.5% pure. Do not use small grain salt.
• When there is moderate to high turbidity, a filter should be installed before the softening system on the inlet side.
• If the water pressure exceeds 80 psi, it is recommended to install a pressure valve. If the water pressure is under 20
psi, a booster pump must be installed before the water inlet.