Instructions / Assembly

G Insert the red brine line flow control (from Parts Bag B) with the cone side facing into control valve, into the

H. Insert brine line into control valve. Tighten the nut onto the brine line connection, as shown in the area

ASSEMBLY INSTRUCTIONS

control valve brine line connector, as shown in the area of magnification below.

of magnification below.

STEP 5: Connect overflow line to brine tank

Note:

There is one 10' length of clear drain tubing. This tubing will need

to be cut to be used for both brine tank drain line and backwash drain

line . You should measure the length y ou need for the backwash line

from the resin tank first, using the remainder for the brine tank drain

line.

Figure 1.2

A. Locate overflow elbow (in Parts Bag A).

Remove nut from threading.

Insert drain

elbow (1) in bottom half of

brine tank below PVC tubing as shown

in Figure 1.2.

Overflow elbow

B. Replace nut on drain elbow inside of brine tank.

Attach clear drain tubing

(2) to the drain elbow. Secure with hose clamp (from Owner’s Manual Zip-Lock Bag).

C. Secure the clear drain tubing over a floor drain or other suitable drain. Check your

local codes to ensure compliance.