Installation Guide

ASSEMBLY INSTRUCTIONS

STEP 1: Attach the Control Valve to the Resin Tank

A. Locate the Master O-ring (from Parts Bag B) and lightly coat with silicone lubricant (from Owner’s

Manual Zip-Lock Bag). Insert into bottom of control valve, as shown below.

Connect the upper distributor, to bottom of control valve, line up slots and twist, as shownbelow.

Center the riser pipe within the resin tank.

Attach the control valve to the resin tank by sliding the upper distributor over the riser pipe.

Securely tighten the control valve by hand, tightening it clockwise.

If you ARE installing the supplied bypass valve, go to step 3.

If you are NOT installing bypass valve, continue to Step 2.

Note: You will have extra parts using either method.

Step 2: Connect Control Valve Input and Output Connections with Flow Meter

Insert blue washers (from Parts Bag B) into input and output connections on the control valve,

as shown below.

Locate pipe fitting connectors(inside control valve box). Remove the plastic clamps on the

connectorst o detach the pipe fitting from the bypass valve connectors.

Screw the threaded end of the pipe fittings into the control valve.

Lightly coat the O-rings on connectors with lubricant before connecting them

into the pipe fittings.