Installation Guide

Operating Conditions
This softening system will operate at maximum efficiency when the following conditions are considered:
Operating Conditions:
Working Conditions
Working pressure 21psi to 120psi
Water temperature
40 °F - 120 °F (5°C - 50°C)
Working Environment
Environment
temperature
40 °F - 120 °F (5°C - 50°C)
Relative humidity
≤ 95% （ When temperature is 25°C/77°F
Power source
AC100 ～ 240V/50 ～ 60Hz
Inlet Water Quality
Water turbidity Down-flow Regeneration < 5FTU
Chlorine < 0.1ppm
Iron
2+
< 0.3ppm
• All plumbing and electrical work should be performed by an accredited professional to ensure all local, state,
and municipal guidelines are met.
• Do not use the control valve with water that is unsafe or of unknown quality.
• Do not use the brine tube, injector body, or other connectors on the valve as a handle to carry the system.
• Ensure there is salt in the brine tank at all times when in use for softening. The brine tank should contain
clean water softening salt only, at least 99.5% pure. Do not use small grain salt.
• When there is moderate to high turbidity, a filter should be installed before the softening system on the inlet
side.
• If the water pressure exceeds 80 psi, it is recommended to install a pressure valve. If the water pressure is
under 20 psi, a booster pump must be installed before the water inlet.
4