Installation Guide

MASTER PROGRAMMING
Step by Step Programming Instructions Continued
Fast Rinse
Time
1. Press
2. Press
3. Press
to enter FastRinse Time, and
along with “5-10:00”value
will flash.
or to adjust the fast rinse time.
to acc
ept adjustments made. Press to advance to the next programming phase.
Maximum
Regeneration
Days
1. Press
2. Press
3. Press
to enter Maximum Interval Regeneration Days, and “H-30” value will flash.
or to adjust the interval regeneration days.
to accept adjustments made. Press to advance to the next programming phase.
Signal
Output Mode
1. Press
2. Press
3. Press
to enter Signal Output Mode, and “b-01” value will flash. or
to adjust the signal output mode value.
to accept adjustments made. Press and return to service status.
After control valve has been programmed, perform the following steps before first use:
•
Press and hold both and buttons simultaneously for 3 seconds to unlock the keypad.
• Press to advance to 2-Backwash; this lets air out of the drain line. Process will take 8-10 minutes to purge the
system.
Note: When you press the screen will display "-00-" as it positions the ceramic discs. Once "-00-" disappears and
the next phase is displayed, you can press to ad
vance to the next phase.
• Press to manually advance through the next phase, 3-Brine & Slow Rinse. Verify the air check valve is closed by
listening to be sure no air is being drawn into the system.
• Press to manually advance to the next phase, 4-Brine Refill. This stage will fill the brine tank with the correct
amount of water. Allow the brine refill phase to run, do not advance past this phase. It should take about 15
minutes for a 1.5 cu/ft system. After this phase has completed, press to manually advance to 5-Fast Rinse, and
again to advance to the Service position.
• Next add salt to the brine tank. (40 lb minimum, 120 lb maximum)
Note: We recommend using pellet salt, NOT solar salt.
• Install brine tank cover.
• Turn a faucet on, away from the installation location, until the water from the plumbing lines has been purged.
• Your water softener should now be fully operational.
• To verify that your water softener is functioning correctly, you can take a water
sample test to verify hardness reduction.
• Tier1 recommends the 10 Panel Water Test Kit by Tier1. Purchase the test at
www.tier1water.com or by calling 1-855-378-9116.
17