Installation Guide

FLUSHING THE WATERLINES
Before operating water softener for the first time, flush out your water lines and the water softener bypass.
• Check that bypass is closed. Knob on top of inlet should be turned to "By-Pass" (side opposite of "In-Serv")
• Turn the water source on at the inlet to your home.
• Disconnect the bypass from the control valve by removing plastic clamps and pulling bypass out of fitting.
• Remove the meter impeller from the bypass by tilting bypass downward until it drops out.
• Place a container under the bypass to collect water. Open the bypass by turning knob on top of the inlet to “In-
Serv” (Service). Allow water to flow through to flush out any foreign material from the water lines.
• Close the bypass by turning the knob on top of inlet back to "By-Pass".
• Reinstall the meter impeller in the outlet as on page 8. Reconnect bypass to the valve and reinstall plastic clamps.
• Open the bypass by turning knob on top of the inlet to “In-Serv”.
• Check for any water leaks.
• Insert the water meter probe into water meter probe dock on the outlet side of the bypass (as on page 9).
SYSTEM STARTUP AND PROGRAMMING
• Attach the power cord to the control valve, and plug in the control valve power cord.
• Open a water line and let water flow until water runs clear.
• Using a pail or pitcher, fill brine tank about 1/3 full with water.
Programming instructions begin on next page.
The factory default settings are on page 15, followed by step by step programming instructions on page 16-17.
A programming key is available on page 19 detailing all button settings.
Please review all settings and adjust as necessary for your water hardness to ensure that the water softener will work
most effectively for your needs.
13