Installation Guide

ASSEMBLY INSTRUCTIONS
C. Secure the clear drain tubing over a floor drain or other suitable drain. Check your local codes to
ensure compliance.
STEP 6: Connect the backwash hose to the control valve
A. Insert washer (from Parts bag B) into ribbed drain connector.
B. Thread ribbed drain connector (from Parts Bag B), onto drain connection.
C. Attach clear drain tubing to connector. Secure using a hose clamp (from Owner’s Manual Zip-Lock bag).
D. Secure the clear drain tubing over a floor drain or other suitable drain.
E. Leave an air gap of about 1 ½” between the end of the hose and the drain. This air gap is necessary to
ensure there will be no back flow of sewer water into the water softener.
STEP 7: Connect control valve input to home water supply.
STEP 8: Connect control valve output to home plumbing.
STEP 9: Flush out water lines and program control valve as on following pages, before first use.
12