Installation Guide

ASSEMBLY INSTRUCTIONS

Insert the red brine line flow control (from Parts Bag B) with the cone side facing into control valve, into the

control valve brine line connector.

Insert brine line into control valve. Tighten the nut onto the brine line connection, as shown in the area

of magnification below.

STEP 5: Connect overflow line to brine tank

Figure 1.2

Note:

There is one 10' length of clear drain

tubing. This tubing will need to be cut to

be used for both brine tank drain line and

backwash drain line. You should measure

the length you need for the backwash line

from the resin tank first, using the

remainder for the brine tank drain line.

Locate drain elbow (1) (from Parts Bag A). Remove nut from threading. Insert drain

elbow in bottom half of brine tank below PVC tubing as shown in Figure 1.2. Replace

nut

on drain elbow inside of

brine tank.

Attach clear drain tubing (2) to the drain elbow. Secure with hose clamp (from Owner’s

Manual Zip-Lock Bag).