Instructions / Assembly

9
this burn time by adding pellets to the hoppers during the burn.
3.2.5 This stove is supplied with a slanted firepot to help burn hotter and longer reducing the ash
content while burning. Clean grate and slots by pulling the pull rod from the back of stove and
pushing it back in. The rod should always be in fully closed position while in operation.
Damper Control is both temperature control as well as combustion efficiency control. To reduce
temperature of stove by 250 degrees open damper to see slots. To increase temperature by 250
degrees close damper fully seeing no slots. Opening damper will also clean up particulates (smoke)
by increasing oxygen to fire.
If the heater runs out of fuel, do not attempt to refuel and light the heater before it has fully
cooled down (approx. 30 min). The unit will smoke excessively if attempted.
4. Storage
4.1 When you are finished using the Heater you should make sure that the fire is completely out.
Allow at least 45 minutes for the heater to cool down before transporting.
4.2 Store the heater upright in a sheltered area away from inclement weather such as rain, snow and
dust.
4.3 This unit is manufactured as an “Outdoor Unit” from steel. If you leave it in the weather it will
accumulate rust. This is normal and can be treated by using touch up paint in spray cans available
from Wood Pellet Products. We Recommend purchasing a cover if you live in a particularly wet
climate.
5. Maintenance
5.1 To obtain the best performance from your heater make sure you perform the following
maintenance activities on a regular basis:
5.2 After a burn and once the heater is completely cooled, clean out any remaining ashes from on top
of the firepot, in-between the bars and in the ash pan.
5.3 Keep exterior surfaces clean. Use warm soapy water for cleaning.
5.4 Never use flammable or corrosive cleaning agents on or near this Heater.
5.5 Airflow through the spark arrester must be unobstructed, clean regularly with canned air.
Glass Cleaning
Only clean stove glass when the heater is off and fully cooled. Should a buildup of creosote or carbon
accumulate, we recommend wiping the windows down with a wet rag. If the glass still appears foggy,
a razor blade can be used to scrape away what remains. DO NOT operate the stove if the glass is
broken.
Caution:
Never burn stick wood or plastic or other combustibles in this heater. Burn only ¼” diameter wood
pellets. Never spray any cleaning product on or into any of the doors, air intakes, or dampers.