Instructions / Assembly

7
Installing the Deluxe Fire Pot:
Insert (XP) the Firepot into the square cutout on the firebox bottom. The 3/8” nut on the bottom of the
fire pot will face towards the rear of the firebox. Make sure the fire pot sits flush with bottom. Place
large washer onto the pull rod. Insert the Pull rod from rear and align with nut on firepot bottom. Turn
clockwise until tight. The pull rod should be pushed in during operation.
Step 3 - Assembling the Ash Pan: Place the (P) Ash Pan Front (with the holes closer to the top)
onto the (O) Ash Pan. Insert two 1/4 x 7/8’’ bolts into the (Q) Ash Pan Handle. Position handle onto
the front of ash pan with the bolts going through the holes. Secure the bolts on the inside with a lock
washer and a 1/4" nut each on the inside. Slide completed ash pan into the front of the firebox.
Step 4 - Installing the Door Mounting Bracket/Door: Mount (L) Door Mounting Bracket with
attached door using two 10/32” bolts. Twist on the spring handles to the door latch and damper dial.
Step 5 - Installing the Stove Top Collar onto the Stove Top: Slip the Stove Top Collar (A) up from
underside of the Stove Top (B) through the center hole. the flange holes need to be aligned with the
holes on the Stove Top. Insert four 10/32” bolts from the top into the holes on the center of the stove
top and fasten with four 10/32” nuts on the underside.
Step 6 - Installing the Stove Top: Place (B) Stove Top on top of (K) Firebox with the beveled edge
facing down on the front of the heater. Secure with twelve 10/32” bolts.
Step 7 - Attaching Hopper Handle and Shut-Off Key (mushroom shaped with wire loop): Place
the shut-off key loop around one handle. Using two 1/4 x 7/8” bolts Align the (Q1) hopper handle with
holes on backside of hopper and secure with a lock washer and a 1/4" nut for each bolt from the
inside of the hopper.
Step 8 - Installing the Hopper Heat Shield: Install (T) Heat Shield by sliding heat shield in between
the hopper and fire box so that the tabs are inserted into the slots located on the (G) and (H) hopper
brackets. Insert from Top down.
Step 9 - Attaching the Spark Arrester to Top Reflector: Attach the (X) Stove Pipe Spark Arrester
(stove pipe piece with logo) to the (Y) Top Reflector using three 10/32” nuts and 10/32” bolts. First,
bend the tabs on the top of the spark arrestor 90 degrees out. Position over holes on the top reflector
and bolt together.
Step 10 - Assembling Stove Pipe and Installing on Stove: Place (W) Stove Pipe on the ground
(on a nonabrasive surface like carpet or rug). Start on the bottom end and gradually connect two
sides of locking pipe. Attach one (W) Stove Pipe to (A) Stove Top Collar with the crimped end up. It’s
easiest to place lock side on to the back of the collar and pull the stove pipe forward then down over
the collar. Place second piece of stove pipe onto the first piece with the crimped end up.
Push down until secure. Place the Stove Pipe Spark Arrestor (connected to the top reflector) onto the
top of the second stove pipe section. Push down until secure. Self-tapping screws included to secure
stove pipe if needed.
Shutoff Key – The stove is supplied with a hopper shutoff key and attachment rope. Hang the key
from the hopper handle. This shutoff key gets inserted into the slot located at the bottom of the