SDS
All concentrations are in percent by weight unless ingredient is a gas. Gas concentrations are in
percent by volume. Components not listed are either non-hazardous or are below reportable
limits.
Composition comments
4. First-aid measures
Move to fresh air. Call a physician if symptoms develop or persist.
Inhalation
Wash off with soap and water. Get medical attention if irritation develops and persists.
Skin contact
Rinse with water. Get medical attention if irritation develops and persists.
Eye contact
Rinse mouth. Get medical attention if symptoms occur.
Ingestion
Direct contact with eyes may cause temporary irritation.
Most important
symptoms/effects, acute and
delayed
Treat symptomatically.
Indication of immediate
medical attention and special
treatment needed
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves.
General information
5. Fire-fighting measures
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Suitable extinguishing media
Do not use water jet as an extinguisher, as this will spread the fire.
Unsuitable extinguishing
media
During fire, gases hazardous to health may be formed.
Specific hazards arising from
the chemical
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Special protective equipment
and precautions for firefighters
Move containers from fire area if you can do so without risk.
Fire fighting
equipment/instructions
Use standard firefighting procedures and consider the hazards of other involved materials.
Specific methods
No unusual fire or explosion hazards noted.
General fire hazards
6. Accidental release measures
Keep unnecessary personnel away. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product
recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid discharge into drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Observe good industrial hygiene practices.
Precautions for safe handling
Store in original tightly closed container. Store away from incompatible materials (see Section 10
of the SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
No exposure limits noted for ingredient(s).
Occupational exposure limits
No biological exposure limits noted for the ingredient(s).
Biological limit values
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Not normally needed. If contact is likely, safety glasses with side shields are recommended.
Eye/face protection
Hard Wood & Laminate Floor Cleaner SDS US
909823 Version #: 01 Revision date: - Issue date: 14-June-2017
2 / 6