Installation Guide

— 2 —
(continued)
7. Disconnect moisture strip connector located in lower right
front corner of the dryer. See Figure 6.
W10712331 A
6. Disconnect the drum light connector located in the top left
front corner of the dryer. See Figure 5.
8. Remove the two (2) lower lint duct screws. See Figure 6.
9. Remove the four (4) screws from the two side edges of the
front bulkhead. See Figure 7.
11. Remove the drum belt tension by reaching into dryer just
under the drum to back side of drive motor. Grasp idler pul-
ley and lift up to relieve tension from belt and remove belt
from motor pulley and lower the idler slowly. See Figure 9.
12. Remove drum from the dryer by grasping the top of the drum
belt and front of drum while sliding drum out of cabinet front.
figure 5

CONNECTOR
figure 6
(2) SCREWS
MOISTURE
STRIP
CONNECTOR
LINT DUCT
10. Remove the front bulkhead and lint duct assembly by lifting it
off the two (2) front hooks (See Figure 8) and then lowering
it to clear the drum support rollers from the drum front.
NOTE: Lift up on front of drum to help lift off of rollers on front
bulkhead.
NOTE: Since the drum belt is still in tension, it will pull the drum
down as you remove the front bulkhead and lint duct assembly.
figure 7
(4) SCREWS
FRONT

figure 8



figure 9
DRUM
BELT
IDLER
PULLEY
MOTOR
PULLEY