Instructions / Assembly

ManualsBrandsUnbranded ManualsArtificial Christmas Trees7.5 ft. Evergreen Quick-Set Artificial Christmas Tree with 550 Color Choice LED Lights

Fig.3

Fig.2

Fig.1

Never allow any part of the set to contact with a source of heat or

flames.

Always position your tree and cable and any extension leads so tha

they will not be a hazard to the elderly, pets and children.

Caution-Artificial trees have small parts which may pose a choking

hazard detached from the branches.

BEFORE YOU START

 Decide on appropriate location for your product.

 Remove all packaging and dispose of safety out of the reach of

children & animals.

 Please note, it is recommended that two people assemble this

item.

These instruction are for your proper use and your safety.

Pleas read them thoroughly before use and retain for future reference.

WARNING-FOR SAFETY

BULB REPLACEMENT INSTRUCTIONS

1. Unplug light string from power source.

2. Pull up on the Bulb Lock (if equipped) unlatching the bulb from the bulb

socket. Gently pull the bulb straight out(Figure 1).

3. Before inserting the new bulb into socket, make sure that the two wires on

either side of the the bulb base are straight up and flush with the base

4. Carefully insert new bulb into socket and push down Bulb Lock (if equipped)

until it snaps into place (Figure 2).

Fig.1

Fig.2

SHAPING INSTRUCTIONS

Shaping the tree branches is the last

step of assembly. The care and

attention given to this final process

will result in a genuinely beautiful

and appealing holiday centerpiece.

1. Every tree style is shipped from

the factory with the tips of each

branch compressed to the center

(Figure 1).

2. Each branch tip must be shaped

to it's proper position to give the tree

a natural look. This is done by gently

grasping the left and right wing tips

and spreading them out away from

the center tip (Fi

gure 2).

3. Each individual tip should then be

spread out separately. Tips should

then be bent slightly upward to add a

more natural looking appearance.

Figure 3 shows a typical tree branch

after shaping.Branch tips should be

carefully pressed back toward center

tip when tree is disassembled for

storage in original carton.

SAVE THESE INSTRUCTIONS

HOW TO ASSEMBLE THE TREE

Each carton contains branch section, and a tree s tand

1. Remove trees and stand from packaging before beginning, keep

carton for future storage.

2. Select an area where the ground is firm enough to hold the tree

upright.

. Take out the tree stand from the carton, unfold it and insert the eye bolts.

Remove packing materials from end of poles, put bottom section pole into

tree stand and mark sure it is seated properly as fig.A. Tighten eye bolts.

Continue by inserting the upper tree section to the lower section until inser

-ting the tree top.

4. Final step is branch shaping. All hinged branches should fall into

lowered position during assembly. Any branches that remain uprigh

should be gently lowered by hand. Please refer to Shaping Instructions

for proper branch shaping technique.

7.5FT Pre-lit PE E-connect Set Tree

SKU# 692639

Model# W-2248-75T

INSTRUCTIONS MANUAL

Retain carton for

storage purposes.

Fig A

OPERATING INSTRUCTIONS

THE SWITCH OPERATES THE FUNCTIONS OF THE LIGHTS.

There are five functions, each one is activated with the press of the switch.

Functions occur in the following order.

FIRST button press turns on steady Soft White lights.

SECOND button press turns on steady Multicolor lights.

THIRD button press turns on fading Soft White lights.

FOURTH button press turns on fading Soft White to Multicolor.

FIFTH button press turns lights OFF

LIGHT FUNCTIONS ALWAYS FOLLOW THIS SEQUENCE.

AND LIGHTS WILL IMMEDIATELY TURN ON AND REMAIN ON FOR

8 HOURS, THEN TURN OFF FOR NEXT 16 HOURS.