Use and Care Manual

2
USE
CAUTION!
❐ Keep children away from the device during operation.
❐ The device should only be used when it is fully and correctly assembled!
❐ Do not reach into the rotating inserts or the feed tube during operation.
❐ Keep hair and clothing away from rotating parts of the device.
❐ Be careful when handling the inserts; the blades are sharp! When removing, or
inserting the inserts, only over touch the plastic parts and never the blades
themselves!
❐ Switch off the device and pull the mains plug out of the plug socket before you
change any inserts or insert or remove the insert holder in order to prevent the
device from accidentally switching on!
❐ Do not operate the device for more than two minutes without interruption!
❐ Do not force food into the feed tube.
To achieve the best cutting results, we recommend that you chop the
food up into smaller pieces before you place it into the feed tube. This
will make it easier to push the food down the tube using the plunger.
Using the Device
1. Place the device on a level, non-slip surface.
2. Connect the device to a properly installed plug socket.
3. Place a bowl beneath the opening of the insert holder in order to catch your
food.
4.Switch on the device by holding down the On/Off
switch. Press the On/Off switch briefly one to two times
before you place any food into the feed tube so that the
cutter insert locks on the drive shaft of the motor unit.
5.Then hold down the On/Off switch and place the food
which is to be cut up into the feed tube.