Instructions / Assembly

20
AREA OF INSTALLATION – CROSS BARS
Step 3 - Assemble Cross Bar to Support Legs
 Attach Cross Bar (# A6 and #A7) to the outer sides of Legs (# A5). Secure using B1, B6, B4 and B3 as
shown below.
REMINDER:
Please note that A7 has two extra holes that will be used for connection to the slide in later
steps. These holes must be located closer towards the front of the swing set where the slide will go down
to avoid the risk of entrapment. The slide can be installed on either side of the swing set. Should you wish
to install the slide on the opposite side, swap A6 with A7
.