Instructions / Assembly

082019 Rev. 4Luxier

Installation - Site Preparation

Installation - Drain Assembly

• Provide sucient oor support. Check the oor at the installation site and make repairs as

needed.

• Waterproof the oor is highly recommended. Finished oor must be level.

• Provide adequate clearance on all sides of the bathtub.

• Minimum of 2 inch waste drain pipe is required.

NOTICE: It is recommended to dry t the parts before installation.

1. Place a large drop cloth on the oor to protect the bathtub.

2. With help, lift the bathtub and place it on its side. Secure the bathtub to prevent it from moving.

3. Connect the 1 1/2” femail adapter as shown in gure 1. Wrap PTFE tape to the thread on the

drain body and connect the adapter.

4. Upright the bathtub and carefully move it to the nal installation position. (NOTICE: Do not drag

the bathtub on the oor as it will damage the bathtub.)

5. Connect the drain assembly to the waste drain pipe. (NOTICE: additional connectors and pipes

are needed to complete the installation.)

Drain Body

Flange Gasket

Overow

Overow Channel

1 1/2” ABS Female Adapter

(included)

Waste Drain Pipe (not included)

Drain Gasket

Locking Nut

NOTE: Drain assembly is pre-installed on the bathtub.

Install the included 1 1/2” female adapter rst and connect

the drain to the waste pipe. (Additional adapter or pipe will

be required to complete the installation)

Fig. 1