Instructions / Assembly

FTF01 Rev.2 042019

Luxier

Installation

COLD

HOT

7. Hold the Tub Filler Assembly (1) in place and install

the four Mounting Screws (3). Check aligment and level

before fully tightening the Mounting Screws (3). After

tightening the screws slide the Escutcheon (2) down to

cover the ange.

8. Connect the Hand Shower Hose (5) to the Tub Filler.

Use an adjustable wrench to connect the Hand Shower

Hose (5) with hex nut end to the Tub Filler. (NOTE:

Make sure the rubber washers (1) are installed on both

end of the hose)

Hand tighten the Hand Shower Wand (6) to the Hand

Shower Hose (5). The Hand Shower Wand should be

placed in the Holder (3) when not in sue.

Remove the aerateor assembly (2) from the spout

and turn on water for couple of minutes and check all

connections for leaks. Move the Handle (4) throughout

the temperature range to ush out any debris in both

hot and cold water lines thoroughly.

Hex Fitting