Instructions / Assembly

FTF01 Rev.2 042019

Luxier

Installation

4-1

4. With the Tub Filler Assembly aligned in the desired

position, mark each of the 4 mounting holes from the

Mounting Flange (1) on the oor.

4-1. Use a drill with 1/4” drill bit, drill the holes 1 3/4” deep

and insert the included Anchors (2). Make sure the Anchors

are ush with the nished oor.

5. Make sure both Hot and Cold water supply hoses pass

through the 2” mounting hole with at least 1 1/4” of the

hose in the oor space.

1/2 " Supplies Hoses

Hot Cold

1 1/4”

Finished Floor

Sub-Floor

HOT

COLD

pipe support

water pipe

6. Apply PTFE tape to the threads of the T-Connector (1)

and the 2 Thread Adapters. Connect the 2 adapters to the

T-Connector (1) and tighten fully. Secure pipe below oor

to oor joist with pipe supports. Connect the 2 water supply

hoses to the T-Connector (1) and use an adjustable wrench

to tighten connections. Do not over tighten the connections.