Installation Guide

Step 3: Verify Measurements in OPEN Posion
Open gate 90 degrees from closed posion.
Measure the distance from the center of hole 2D on the Post Bracket (#2) to the center of the Gate Bracket (#3).
The distance MUST measure 22” or MORE. If the distance is less than 22”, start back at Step 1.
Once you have verified all measurements, close the gate and secure all mounng brackets.
INSTALLATION INSTRUCTIONS CONTINUED:

Gate
Post
2A
2B
2C
2D
G
A
T
E

Gate in OPEN posion:
Open gate
90 degrees
from closed


Gate
Post
G
A
T
E
Install a Gate Stop:
Step 4: Install your LockeyUSA TB Gate Closer
Grease Securing Pins (#5) with light silicone grease.
Place “Post End” of your gate closer to Post Bracket (#2).
Secure using a greased Securing Pin (#5) and two Spacers (#6), one spacer on top and one on boom of the closer.
Secure with a Washer (#8) and Cap Screw (#7) and ghten (shown to the right).
Next, open the gate slightly to align the hole on the “Gate End” of the gate closer to Gate Bracket (#3).
Secure using a greased Securing Pin (#5) and two Spacers (#6), followed by a Washer (#8) and Cap Screw (#7).
Tighten.
With gate closer secured to the gate, slowly open the gate to remove Retaining Bar (#9).
IMPORTANT: A gate stop MUST
be installed to prevent gate from
opening beyond 90 degrees.
Opening past 90 degrees will
cause hyper-compression which
will damage the closer.
LockeyUSA manufactures the
GS90-MD and GS90-HD, along
with the Chainlink Compable
Gate Stop, GSLINX.
To adjust speed/force:
Move gate closer to desired mounng hole.
A= Least Closing Force/Fastest Closing Speed
D= Maximum Closing Force/Slowest Closing Speed
Visit www.LockeyUSA.com for
more gate security products.
Gate
Post
B
A
D
C
Faster
Slower
Speed
Minimum
Maximum
Force

Gate
Post
2A
2B
2C
2D
Gate

Gate Closer Installed


Measurement from
hole 2D to the center
of Gate Bracket (#3)
must be greater than
or equal to 22”