Instructions / Assembly

Tamper-Resistant Screw
Holsters
Instrument Post
Swirl Instrument
Assembly
3
16
" Predrilled
Holes 5" Deep
T25 Torx, 4" lg. Screws
INSTRUMENT TO POST INSTALLATION PROCEDURES
Step 1:
To ease the installation of the Swirl a 2x4 Brace has been added to the back of the Instrument. When the Swirl is face down there is some flex that is not
present when it is upright. To install the Swirl have two people pick it up, rotate it to where it is upright, remove the brace than continue to the next step.
Step 2: (Recycled Post Only)
With two people, situate the instrument onto the posts. Predrill 1/8" pilot holes into the posts through the existing holes on the
instrument holster. Fasten the instrument to the posts with the provided 1 1/4" tamper-resistant screws and security driver.
(Steel Post Only)
With two people, situate the instrument onto the posts. Predrill 11/64" pilot holes into the posts through the existing holes on the
instrument holster. Next tap the holes with the provided 10-24 Tap, the Tap may be used with a cordless drill. Last fasten the instrument to the posts with
the provided 1" tamper-resistant screws and security driver.
Step 3:
Locate the (4) predrilled holes on the front of the Instrument at the center of each Holster. With a 3/16" extended drill bit, predrill through the existing
holes into the Posts 4" deep. Install the T25 Torx, 4" lg. Screws from the front of the Instrument into the posts.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
FREENOTES HARMONY PARK IS
PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
EMAIL: [e-mail]
WWW.FREENOTESHARMONYPARK.COM
SHEET 6 OF 6
SCALE: 1:7
PRODUCT SHEET / INSTALLATION GUIDE
SWIRL 2016