User Manual

Pg. 15
RPM Acceleration Curve/Delay time
Set FULL (high speed) - The ECU will
automatically calculate the response of
IDLE the acceleration rate of value (low
speed). Adjust according to weather,
Altitude (ASL) or other conditions which
require adjustments to delay time. It is
best to select a value that is lower than a
setting that yields the fastest possible
response time in order to avoid a flame
out.
IDLE change low rpm acceleration. Lower
number yields
Test function menu
Press “OK” to access test functions
Test Pump – depress OK and hold OK to
increase pump speed. Pump increases
gradually. Test pump initiates fuel
solenoids simultaneously. Be careful not to
flood the engine.
Test Fuel Valve – press “OK” to activate
fuel valve.
Test Gas Valve – press “OK” to activate Gas
Valve – this controls fuel to the glow plug.
Test Glow Plug – press “OK” to activate
Glow Plug circuit. A glow can be seen
from the rear of the motor.
Test Starter – Press “OK” to activate
starter. Use this function to manually
cool the motor. RPM speed of starter is
set in the startup menu