User Manual

Pg. 12
Main Menu – Display all Parameter Screen
Same as last screen with these additional
functions
Starter – set starter parameters
Calibrate fuel – secondary screen for fuel
parameters(factory setting)
Start Up Screen (advanced functions)
PumpVoltage – Pump start voltage – begin
with this value and increase according
to ramp value.
GlowPlug – Set Glow Plug starting voltage.
PumpVoltage - Set pump voltage Typical
value is .5
RPM StartUp Ramp – Set ramp profile
PumpStartUp Ramp - This parameter
adjusts the speed of the fuel increase
during the “Fuel ramp” phase. Higher
values mean a faster fuel flow increase.
Increase this value if the engine takes too
long to arrive to idle, and decrease it if the
starts are too hot, with the engine
overshooting the idle speed.
Pump Auto - Sets the power of the pump
when it is started at beginning of the fuel
ramp. The ECU has the ability to
automatically adjust the pump power to
start it at the lowest possible speed.
GlowPlug – Set Glow Plug Voltage.