User Manual

18
Fuseinuse
Sparefuse
FuseHolder
1. Use  a  screw  driver  to  pop
openthefuseholder,slidethe
fuseholderout
2. Check  if the fuse  in use  is
blown.  If  blown/damaged,
detach  the  spare  fuse  and
attach  to  the  active  fuse
holder.）
3. Reattachthefuseholder.
CHANGING THE FUSE
Checkingthefuse:
The Fuse can be found at the back of the unit, it is incorporated
intotheACpowerreceptacle.Iffuseisblownreplacewithsametype
fuseonly.
Sparefuse
holder
Activefuse
holder
7
Aoyue936 规格
480°C
I. SOLDERING IRON HOLDER
1. Installsolderwiretothesolderironholder.(Fig.1)
2. Dampen the cleaning sponge with water, squeeze it dry and
placeitinitsbase.(Fig.2)
II. SOLDERING IRON
1. Attach the soldering iron to the receptacle connector at the
bottomrightareaofthemainunit.
2. PlacesolderingirontothesolderingironstandasshowninFig.1
3. Plugthepowercordintoareceptaclewithground.
III. MAIN UNIT
1. Turnonunitand
2. Whentheheaterlampblinksonandoffthenitmeansthatthe
tiptemperaturehasreachedthesettemperature andisreadyfor
use.
Fig.1
Fig.2
Solderingironmustbeplacedinthe
ironholderwhennotinuse.
Failuretodampenspongemight
damagethesolderingtip.
ASSEMBLY and USAGE
Powerindicator
Heaterlamp
Calibrationpoint
Main  power
switch
Temperature
adjustmentknob
Powercord
Handpiece
receptacle