User Manual

6
SPECIFICATION
Model#
Power Consumption
60W 35W
Fuse
1A 0.5A
MAIN STATION
Output Voltage
24V 24V
Temperature Range
200—480°C
392—896°F
200—480°C
392—896°F
Dimension
110(w)×93(l)
×168(h)mm
110(w)×93(l)
×168(h)mm
SOLDERING IRON
Power Consumption
24V—60W 24V—60W
Tip to Ground
Resistance
Lessthan2Ohm Lessthan2Ohm
Tip to Ground Potential
Lessthan2Ohm Lessthan2Ohm
Heating Element
Japanmade
CeramicHeating
Element
CeramicHeating
Element
Power Cord
1.1meters 1.1meters
Length
1.2meters 1.2meters
Weight
108grams 100grams
Design and specification might change without prior notice.
SPECIFICATION
19
SPECIFICATION
BASIC TROUBLESHOOTING GUIDE
WARNING: To avoid personal injury or equipment damage,
disconnect powercords beforemaking any servicingtothe
equipment, or unless instructed otherwise in the
troubleshootingprocedures.
PROBLEM1:THEUNITHASNOPOWER/MAINPOWERLEDDOESNOT
LIGHTUP
1. CheckiftheunitisswitchedON.
2. Checkthefuse.Replacewiththesametypeoffuseifblown.
3. Checkthepowercordandmakesuretherearenodisconnections.
4. Verifythattheunitisproperlyconnec tedtothepowersource.
Additionalprecautions:
Checkinternalcircuitryforshortsthatmaycausetheblownfuse.See
“TroubleshootingConnections”
onpage1315.
Checkfortanglesofwiresintheheatingelementcausingittoshort.
See
“TroubleshootingConnections”
onpage1315.
PROBLEM2:SOLDERINGIRONDOESNOTRISEINTEMPERATURE
Description: Main power LED lights up and so does the heater LED but
solderingirontemperatureisrelativelowandisnotheatingup.
SOLUTION:
Soldering iron cord may be damaged and needs to be replaced or
repaired.See
“TroubleshootingConnections”
onpage1315ofthismanual.
Heatingelementmaybedamagedandneedstobereplacedsee
“Testing
theHeatingElement”
onpage11and
“ReplacingtheHeatingElement”
onpage
12onthismanual.