Technical Data Bulletin

ADVANCED BUILDING PRODUCTS SPECIFICATIONS APRIL 2002
Advanced Building Products, Inc., P.O. Box 98, Springvale, Maine 04083
TEL: [phone]; FAX: [phone]; WEBSITE: www.advancedbuildingproducts.com
______________________________________________________________________________
SELF-ADHERING CAVITY WALL MEMBRANE 04090.4 - 2
during delivery, storage, and application.
B. Store in clean, dry area away from open flame, sparks, or welding.
PARTS 2 - PRODUCTS
2.1 ACCEPTABLE MANUFACTURERS
A. Advanced Building Products, Inc., P.O. Box 98, Springvale, Maine 04083; 800-
252-2306; www.advancedflashing.com
B. Manufacturers of equivalent products submitted and approved in accordance with
Section 01630 - Product Substitutions Procedures.
2.2 PRODUCTS
A. Self-adhering, waterproof membrane with siliconized release liner; Strip-N-Flash®
as manufactured by Advanced Building Products, Inc.
1. Total thickness: 40 mils.
2. Composition: 32 mils rubberized asphalt laminated to 8 mils high density
polyethylene film.
***** Strip-N-Flash® is provided in 12, 16, 18, and 24 inches (305, 406, 457, and 610
mm) widths. Select required width in following paragraph. *****
3. Width: [[12] [16] [18] [24] inches.] [[305] [406] [457] [610] mm.]
4. Tensile strength: 1,200 PSI minimum tested in accordance with ASTM D412.
5. Elongation: 200 percent tested in accordance with ASTM D412.
6. Pliability: Pass 1/4 inch mandrel test at minus 24 degrees tested in accordance
with ASTM D146.
7. Peel adhesion: 5 pounds per inch minimum tested in accordance with ASTM
D903.
8. Puncture resistance: 40 pounds minimum tested in accordance with ASTM
E154.
B. Primer: As recommended by membrane manufacturer for substrate.
PART 3 - EXECUTION
3.3 INSPECTION