Instructions / Assembly

2
Box 2: Function panel with pressure valve, water hoses, body jets, and electronic
control
Box 3: Two framed glass back wall panels
Box 4: Shower base and top, and hardware box
Box 5: Two front panels, top and bottom tracks, two 90 degree aluminum channel angles
★Hardware included:
1. Drain with flexible hose if you ordered 1-1/2” drain. It doesn’t come with a drain piece or
flexible hose if you ordered 2” drain. You can buy 2” drain at a hardware store.
2. up washers and decorative chrome covers for mounting the function panel to back walls
3. 7/8” iron screws (8pieces), ½” stainless steel screws (20 pieces), and 1/4" (4 pieces) screws
4. Glass shelf and its mounting bolts, washers, rod connectors and nuts
5. Shower head sliding bar and its mounting bolts, washers and nuts.
6. Flexible water hose for hand-held shower and through-wall elbow, washers and a ring nut.
7. Hand-held shower head
8. Door rollers (the spring-loaded rollers shall be installed at doors’ bottom)
9.Door handles
10. Shampoo and soap dispensers, their mounting base and its mounting bolts, washers,
nuts (4)
★1. Pre-installation
a. Check the area you want to install your unit for the following:
b. Water hook-ups, one hot and one cold with ½” FIP female connectors on ½” PEX or
flexible hoses. Floor drain (2” hard-plumbed drain is the US standard). This unit
doesn’t come with water supply hoses and 2” shower drain piece.
c. Measure the area to ensure that once the unit is installed, the screw holes located at the
top of the enclosure walls will align with a wall stud.
d. 120V wall outlet preferably located at 82” above the floor 16” from the corner so that
you can access it easily for the future.