Instructions / Assembly

10
★9. Unit installation
a. Connect and secure all water lines to the shower enclosure. Make sure all connections
are water tight! If your unit comes with a built-in radio, plug it into a 120V outlet.
b. Match up the electrical wire connectors (by pictures on the tags) for LED lights,
speaker, and fan. (The DC powers both lights If your unit has both dome and panel
LED lights.)
c. You may apply silicone sealant to the outer edge of the base.
d. Secure the unit to the wall using the 3” dry wall screws. Drill a pilot hole (1/8”) on the
top of the angle toward wall studs. You have to drill in a slanted angle. Drive the dry
wall screws through the holes. The screws MUST be screwed into a stud or a drywall
anchor.
★10. Caulking
Use silicon sealant to
seal all the seams or
joints from inside
the shower
.