Installation Guide

4
l. Easy-Fit Drain Connections Recommendations:
For remodeling and when the floor drain and shower drain don’t line up, please use
Easy-Fit Drain as follows:
(i). Use 4” to 1-1/2” PVC Reducing Coupling (Canplas 193023) to reduce the 4” floor
drain to 1-1/2”. Don’t glue down until all parts lined up and tested fit!
(ii). Use 1-1/2” X1-1/4” PVC 90 degree elbow to reduce the drain pipe further to 1-
1/4”. There are other ways to reduce 1-1/2” to 1-1/4” too.
(iii). Use 1-1/4” to 1-1/4” coupling to connect 1-1/4” hard PVC to 1-1/4” flexible PVC
hose (brand: EZ-Flo 1-1/4”).
(iv). Connect flexible 1-1/4” hose to Easy-Fit drain. Make sure that flexible hose
doesn’t have any sharp turns.
Note: All parts described in this section are not included with the shower kit except
Easy-Fit Drain. Drain and water supplies are part of the house plumbing.
Professional plumbers are recommended.
★3. Front Frame Assembly: connection of big stiles to tracks
a. Assemble the front frame of two front panels and two straight door tracks.
b. It is recommended to work on a big working table covered with a soft blanket
c. The wide track is the bottom track and narrow track is the top. Each track has an U
groove for door rollers.
d. The U groove on the top track faces inside and U opens toward top (Flat edge of the
track is on top).
e. The U groove on the bottom track faces inside and U opens toward bottom.
f. Connect tracks to the vertical stiles with two metal screws as shown by the illustration.
g. The pictures below are for illustration of how stiles and tracks are attached only. The
tracks for S-3460 are straight.