Full Product Manual

8. Unit Assembly
a. Connect the front frame with two side-back walls. Set both back panels on top the base and close to their designated
locations. Both back walls should have all their necessary components installed.
b. Set the front frame onto the base. Push a back wall to the frame and pull against L edge of the front frame post #37.
Use 5 of ½” stainless steel screws to secure the back wall to the front frame. Repeat the same procedure for the other
back wall.
c. Put the function panel close to its designated place and connect both hot and cold water supplies, water supplies to
overhead shower, hand-held shower, body jets. Make sure all connections are water tight!
d. Connect electrical wires to LED lights, Fan, and speaker. The wires have labels of their uses.
e. Place the roof of the unit on top of the shower enclosure, aligning it with the walls, and fixing it to the wall studs
through the edge foldup.
f. Secure function panel to the back walls with ½”screws, cup washers, and chrome covers.
g. Secure front frame stiles #37 to drywalls with 3” drywall screws and anchors through the holes at the top at a 45
degree angle.
Backwall is attached to the stile of the front frame