Full Product Manual

Shower Drain and Water Supply Recommendations
Water Supplies:
1. The shower control valve needs ½” FIP Connections
2. Shutoff valves should be used for both hot and cold water supplies
3. 3-4 feet long flexible water hoses must be used from shutoff valves to shower control
valves
A. If Pex used, please use ½” FIP of swivel type for easy installation
B. If Pex is not used, please use plastic or stainless braided hoses with ½” FIP connectors
at the shower’s control valve connection
Drain Connections:
1. For new constructions, please plumb the floor drain to the exact location of the shower
drain, and use 2” shower drain such as Oatey.
2. For remodeling and when the floor drain and shower drain don’t line up, please use Easy-
Fit Drain as follows:
A. Use 4” to 1-1/2” PVC Reducing Coupling (Canplas 193023) to reduce the 4” floor drain
to 1-1/2”. Don’t glue down until all parts lined up and tested fit!
B. Use 1-1/2” X1-1/4” PVC 90 degree elbow to reduce the drain pipe further to 1-1/4”.
There are other ways to reduce 1-1/2” to 1-1/4” too.
C. Use 1-1/4” to 1-1/4” coupling to connect 1-1/4” hard PVC to 1-1/4” flexible PVC hose
(brand: EZ-Flo 1-1/4”).
D. Connect flexible 1-1/4” hose to Easy-Fit drain. Make sure that flexible hose doesn’t
have any sharp turns.
Note: All parts described in this section are not included with the shower kit except Easy-Fit Drain.
Drain and water supplies are part of the house plumbing. Professional plumbers are
recommended.