User Manual

www . SkylarkFPV . com
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION GUIDE
GUIDE
GUIDE
GUIDE
CONFIGURATION
CONFIGURATION
CONFIGURATION
CONFIGURATION
A three-way switch is equipped, and each way corresponds to 1 display mode. If the channel for transfer
switch is not connected,
details-mode
would be displayed by default.
The current sensor and voltage detector are tuned before delivery, if there are relatively high deviations,
please contact us for the tuning software.
DISPLAY
DISPLAY
DISPLAY
DISPLAY MODES
MODES
MODES
MODES
There are 3 display modes:
details-mode
,
simple-mode
and
alarm-mode
. These 3 modes can be switched
by a three-way switch on the remote control. Please refer to the Operation Procedures section for the
specific switching methods. Here are the introductions for these 3 display modes:
Details-mode
Details-mode
Details-mode
Details-mode
Details-mode
displays most of the indication information, including
latitude, longitude
,
numbers of GPS
satellites
,
speed
,
altitude
,
scrollbar
,
flying direction
(shown by the plane icon),
existing location &
direction
corresponding to the point of departure,
returning angle & direction
,
horizontal distance
corresponding to the point of departure
,
current
,
voltage
,
electricity consumption
,
remaining electricity
,
flying time
and
signal indication of remote control
, which are shown in the following diagram. The
rectangle in the center is the display range of the plane icon.
As a warning, many of the displayed information would flash.
When the GPS signal is not strong enough,
latitude, longitude, numbers of GPS satellites, speed, altitude,
the plane icon,
returning angle & direction
,
horizontal distance corresponding to the point of departure
would be flashing. When the signal becomes fine, flashing would stop automatically.
When user enters this mode the first time after charging, if positioning of the GPS has not yet been
completed,
latitude
and
longitude
would not be shown. The display area would appear the flashing words
of
GPS Searching Data
, which means the GPS is still searching for the satellites. To guarantee the
navigation information is accurate, please wait until the
latitude
and
longitude
data are displayed before
takeoff.
If the device is under interference,
signal indication of remote control
would flash for certain seconds, so
as to warn the user that it is out of the control range.
When there is a SD card,
SD Card Indication
would be displayed. If there is problem in data saving, this
display information would flash.
When it is under voltage because of not enough electricity (for example, the voltage of 3S battery is lower
than 10.6V), the
voltage
and
remaining electricity
would be flashing to remind user to take appropriate
actions, such as starting the return journey.