User Manual

www . SkylarkFPV . com
System would detect the equipments that connected to the OSD control board automatically, then the
software & hardware version would be displayed.
Meanings of the information shown above:
HW
HW
HW
HW 4
4
4
4 .0
.0
.0
.0 & SW
SW
SW
SW 1
1
1
1 .0
.0
.0
.0 : represents hardware and software version are 4 .0 and 1 .0 respectively.
Logger
Logger
Logger
Logger : represents if the data logger is detected by the system. It flashes if the data logger is not
detected.
GPS
GPS
GPS
GPS /INS
/INS
/INS
/INS : represents if the GPS /INS is detected by the system. It flashes if GPS /INS is not detected.
RC
RC
RC
RC CH
CH
CH
CH IN
IN
IN
IN : is the RC receiver input channel
About 10 seconds after power connection, the system will enter one of the three modes. (It depends on
the switch status of the remote control.)
If the displayed information is different from the equipments connected, please check again before
take-off.
SOFTWARE
SOFTWARE
SOFTWARE
SOFTWARE SETTING
SETTING
SETTING
SETTING
A
A
A
A
After
After
After
After OSD
OSD
OSD
OSD initialization
initialization
initialization
initialization iscomplete
iscomplete
iscomplete
iscomplete ,
,
,
, the
the
the
the following
following
following
following menu
menu
menu
menu would
would
would
would be
be
be
be shown:
shown:
shown:
shown: