User Manual
ESCLinker v1.0
Multifunction tools, compatible with SIMONK and
BLHELI ESC(With or without Bootloader)*,supports
ISP and C2 Mode to flash new MCU(which hasn't
installed Bootloader)
* Only ISP or C2 mode possible when there is no bootloader
preinstalled
** Arduino as ISP
*** Using BLHELISUIT
* 没有 Bootloader 的情况下,只能使用 ISP 与 C2 模式
** 以 Arduino as ISP 方式
*** 通过 BLHELISUIT
兼容 SIMONK,BLHELI 电调, 可以支持 ISP**、C2***、
舵机线等多种连接方式的电调联机器
• Direct plug design, works with most USB port and USB Extension
Cable
• Low power consumption design
• On board 2x3 Pin AVR ISP port
• 3pin Servo connector, can be used as Servo or C2 connection
• Supports SIMONK and BLHELI ESC
• Software upgradeable (Via Arduino or BLHELISUIT)
• Pre-Load as BLHELISUIT 4w-if 14.1 firmware
PD3 / D3 C2D Signal
Pin Name C2 Mode Servo Mode
PD2 /D2 C2CK NC
GND GND GND
• 直插式设计,兼容几乎全部 USB 口和 USB 延长线
• 低功耗设计,对 USB 电压要求极低
• 板载 2x3 6pin AVRISP 口
• 板载 3pin 舵机口,可以通过舵机线连接电调,或作为 C2 口使用 ***
• 支持 SIMONK 与 BLHELI 全系列电调
• 软件可升级,可自定义
• 出厂预装最具实用性的 BLHELISUIT 4w-if 固件
Short for Self ISP program
GND RST
MOSI SCK
VCC MISO