Instructions / Assembly

TOOLS REQUIRED:
• 3/16” Drill
• #3 Square Driver
INSTALLATION:
1. The 18 in. Sepc Tank Riser Cover will t most 18” installed risers. Test t the 18 in. Sepc Tank Riser
Cover to make sure it is correct for your riser.
2. Clean the sealing surface of your riser.
3. Remove the hardware pack containing the four square-drive screws from the back of the 18 in. Sepc
Tank Riser Cover.
4. Place the 18 in. Sepc Tank Riser Cover on your riser. Make sure the rubber seal is making a seal with the
top of your riser.
5. Using the four screw holes in the cover as a guide, drill four 3/16” holes through your riser.
6. Some risers may require the use of holes other than the molded screw holes into the 18 in. Sepc Tank
Riser Cover. For these risers, use the two addional drill points molded on the top of the cover.
7. Install the provided screws with a #3 square driver.
8. For access to your riser just remove the screws and cover, then reinstall as above.
18 in. Sepc Tank Riser Cover
Installaon Guide
Model # SFRC18G
Jackel, Inc · 15314 Harrison Road · Mishawaka, IN 46544 · [phone] · [phone] fax · www.jackelinc.com